Fireangel FA3322 Digital CO Alarm with 10 Year Sealed For Life Battery and includes Temperature and Humidity Sensing and Warnings

Product Information

Most people will not experience any symptoms from prolonged exposure to CO levels of under, say, 40ppm. It depends on the length of exposure, but the real danger level starts at around 400ppm (two to three hours of exposure at this level can be life-threatening). To give you some idea of how dangerous higher levels of concentration can be, 1,500ppm could result in death within an hour and 6,000ppm within 15 minutes. The advice below is purely provided for ‘best practice’ and should not be used independently. Please note, these alarms are not suitable for homes in Scotland under the new Fire & CO regulations. All of these concentrations are bad enough when you’re awake and realise that something isn’t quite right – especially if others are feeling a similar effect – but if you’re asleep, you may wake up with a severe headache and nausea and be incapable of even crawling for fresh air. Worse, you might not even wake up at all. Why should I be concerned?

Following the tragic fire at Grenfell Tower in London, a Ministerial Working Group on Building and Fire Safety was established to review Scotland’s building and fire safety regulatory frameworks. This legislation will ensure that everyone in Scotland has the same level of protection whether they own or rent their home.’ The alarm’s high sensitivity mode will be enabled if the alarm predicts CO levels will increase to or above 180ppm for fast reaction to rising CO levels.Our Pro Connected Alarm range is compatible with the Wi-Safe2 products, so you can extend this network easily using the steps outlined in the manual.

When alarms are interlinked you can press the test button on one of the alarms to test the whole network. To make life even easier you can install our Smart Gateway in to your Pro Connected alarm range which enables you to test the alarms through the app – or you can even enable the Alexa skill and then Just Ask Alexa to test them! The FA3820X4 Carbon Monoxide Alarm offers a variety of safety features, including Ventilate Instruction, Alarm Memory, Sleep Easy and Quiet Self Test. Creating a network of protection is simple with the Pro Connection alarm range – if you’re installing battery powered products you won’t even need an electrician. Mains powered alarms are powered by your home’s electricity supply and can be identified by a light which indicates they are connected to the mains power. Battery powered alarms do not have a green light and when removed you will have a flat base plate without any connections. For safety reasons If your alarms are mains powered or you are not sure, you should consult a qualified electrician or the manufacturer for advice.

CO detectors should be installed near potential sources of carbon monoxide, essentially any fuel-burning appliances such as boilers, cookers and ovens, fireplaces (both open and enclosed burners), and portable generators. As you are likely to be most affected by CO in areas of your home that you spend the most time in it is advisable to install alarms in those areas as well, such as the living room and bedrooms. It is also worth noting that while one detector is better than no detectors at all, larger homes may require several detectors to cover the property fully. A wireless interlinked network is established using radio frequency – which means that additional alarms can be added to a network at any time. The FA3313X4 is the ideal replacement for end-of-life FireAngel CO-9B alarms, featuring the highest level of CO detection for your home. With intelligent CO sensing technology and built-in features including Sleep Easy function and Alarm Memory, this alarm will keep your family protected from carbon monoxide.