Rothenberger 80000 Monoblock Tap Spanner Set

Product Information

Dual Flow tap. A dual flow tap is a great alternative to a mixer tap if your hot and cold water runs at different pressures. A dual flow tap will keep the hot and cold-water streams separated until they are combined as they come out of the tap. Before actually removing or replacing any part of your water system it’s advisable to first turn the water off and drain down the system if you can.

Fit horseshoe rubber and plate over the threaded rods under the sink and screw on the nuts and tighten with a box spanner. Water filter taps. With an in-built water filter, these taps help to filter out excess chlorine and impurities from the water making them ideal as part of a kitchen sink. Once the tap has been dropped through the hole and the flat washer or mounting plate place over the threaded bars, it is time to slide the steel washer in place. Locate the tap hole in your basin from which you previously removed the old tap. The tap tails and fixing studs should be lowered down into the hole. Also make sure the tap is perpendicular to the rim of the basin.Completely removing the nut from the stud will allow the tap to be removed complete with its flexible hoses. Make sure no associated washers or seals are left hanging up. Take care when you withdraw the hose ends, especially on stainless steel sinks where sharp edges can figure. Learning how to change bath taps is quite a bit different and can be a lot harder! How to Change a Kitchen Tap How to Remove a Kitchen Tap Pop-up waste. A pop-up waste tap helps you to empty the sink with a mechanism that means you do not need to pull the chain and plug – simply use the tap instead! Pull-out Spray Mixer. With an extendable hose, this tap is perfect for rinsing dishes and food and can be used to control the flow of the water. Hoses are pre-fitted to mixer taps. If not, screw the hoses into the tap base carefully, tightening by hand only. Follow the instructions which come with the tap. Feed the mains connection ends through the location hole - be careful with the sharp edges on stainless steel sinks and make sure any seals, gaskets, washers and studs are pre-fitted and located according the instruction’s steps.

To make the process as easy as possible for you, we’ve collated all the relevant information you’ll need. See the headings below! Make sure you turn the water supply off first and make sure to tighten the nuts up securely as you don’t want the tap coming loose after a few uses. Though fitting a full bathroom suite is a job you’ll want to get a professional in to do, if you’ve got a bit of DIY and plumbing experience, then fitting a mixer tap to the basin in your bathroom is a job you can do relatively easily. Once you have removed the old, faulty tap and have your new mixer tap ready to be installed, it’s a case of putting it in place and securing it by following the steps you took to remove the mixer tap, but in reverse.If your caravan or motorhome mixer tap has become loose or started leaking then chances are you’ll probably need to replace it. Depending on the make, model and age of your leisure vehicle, replacing this tap could be straightforward or a little more time consuming. In most cases you can either find advice from your manufacturer, parts supplier or online via the wealth of information that has been shared by other caravan or motorhome owners. If you’ve come across this blog then we’ll do our best to share some basic guidance on how to replace a caravan mixer tap and point you towards the mixer tap spares we offer to help you get the job done. How to remove a caravan mixer tap